![background image](http://html1.mh-extra.com/html/daikin/m08b055/m08b055_installation-manual_2460255003.webp)
Indoor Unit Installation Drawings
Intelligent-eye Sensor
1) Do not hit or violently push the intelligent-eye sensor. This can lead to damage and malfunction.
2) Do not place large objects near the sensor. Also keep heating units or humidifiers outside the sensor’s detection area.
CAUTION
Moving the sensor to the left
Moving the sensor to the right
Intelligent-eye
sensor
15˚ 15˚
Adjusting the angle
1) Once installation of the indoor unit is complete, adjust the
angle of the Intelligent-eye sensor to ensure the detection
area properly covers the room. (Adjustable angle: 15˚ to
right and left of center)
2) Gently push and slide the sensor to adjust the angle. Aim so
that the sensor is pointing to the center of the room, or to
the part of the room that is most frequently used.
3) After adjusting the angle, gently wipe the sensor with a clean cloth, being careful not to scratch the sensor.
Cut thermal insulation
pipe to an appropriate
length and wrap it with
tape, making sure that
no gap is left in the
insulation pipe’s cut line.
Caulk
pipe hole
gap
with putty.
1-3/16” (30mm) or more from ceiling
Front panel
1-15/16” (50mm) or more from walls
(on both sides)
B 3/16” × 1”L
(M4 × 25mm)
The mounting plate
should be installed
on a wall which can
support the weight
of the indoor unit.
A Mounting plate
Air filters
Install Air-purifying filter with photocatalytic
deodorizing function on air filter
D Wireless
remote controller
E
Remote
controller holder
Before screwing the remote
controller holder to the
wall, make sure that control
signals are properly
received by indoor unit.
1/8” × 13/16”L
(M3 × 20mm)
F
Wrap the insulation pipe with
the finishing tape from bottom
to top.
A Mounting
plate
Clip
Mark (rear side)
Front grille
Bottom frame
■
How to attach the indoor unit.
Hook the claws of the bottom
frame to the mounting plate.
If the claws are difficult to hook,
remove the front grille.
■
How to remove the indoor unit.
Push up the marked area (at the
lower part of the front grille) to
release the claws.
If it is difficult to release, remove
the front grille.
Service lid
Opening service lid
Service lid is opening/closing type.
Opening method
1) Remove the screws on the
service lid.
2) Slide the service lid leftward.
3) Rotate the service lid upward.
C Air-purifying filter with photocatalytic
deodorizing function
C
Air filter
Air-purifying filter
with photocatalytic
deodorizing
function