Instruction
Si04-115
46
System Configuration
6
n
Setting the batteries
n
Operating the remote controller
l
To use the remote controller, aim the transmitter at the indoor
unit. If there is anything to block signals between the unit and
the remote controller, such as a curtain, the unit will not
operate.
l
Do not drop the remote controller. Do not get it wet.
l
The maximum distance for communication is about 7 m.
About the remote controller
l
Never expose the remote controller to direct sunlight.
l
Dust on the signal transmitter or receiver will reduce the
sensitivity. Wipe off dust with soft cloth.
l
Signal communication may be disabled if an
electronic-starter-type fluorescent lamp (such as
inverter-type lamps) is in the room. Consult the shop if that
is the case.
l
If the remote control signals happen to operate another
appliance, move that appliance to somewhere else, or
consult the shop.
n
To fix the remote controller holder
on the wall
Choose a place from where the signals reach
the unit.
Fix the holder to a wall, a pillar, etc. with the
screws supplied with the holder.
Fit the claw of the holder into the bottom of
the remote controller, and push the remote
controller onto the wall.
Remote controller
1
2
3
l
To remove, pull it upwards.
Preparation Before Operation
ATTENTION
+
–
–
+
Position + and
– correctly!
2
3
1
Remote
controller
holder
Set.
Receiver
1
2
3
Press
with a finger and slide the front
cover to take it off.
Set two dry batteries (AAA).
Set the back cover as before.
l
This will cause the figures on the display to flash. Set the
clock at this point.
About batteries
l
When replacing the batteries, use batteries of the same
type, and replace the two old batteries together.
l
When the system is not used for a long time, take the
batteries out.
l
When the operation display screen of the remote controller
is hard to see and the reception become hard, replace the
batteries with new AAA batteries.
l
The attached batteries are provided for the initial use of
the system.
The usable period of the batteries may be short depending
on the manufactured date of the air conditioner.
ATTENTION
(R1928)
