12
English
3/8 to 5/8
(10 – 15)
2-3/4 to 3-1/2 (70 – 90)
L
1
L
2
Conduit mounting plate (17)
(Accessory)
<1-3/8 (35)
≥
3/8 (10)
[in. (mm)]
[in. (mm)]
Screw
Power supply and
ground wire
Conduit mounting
plate (17)
(Accessory)
Insulation
tube (16)
(Accessory)
Wiring diagram label
(on backside of control box cover)
Control box cover
Remote
controller wiring
Transmission
wiring
Wiring
through hole
(low voltage)
R3/8 (10)
or more
Clamp (4)
(Accessory)
Sheathed part of
remote controller wiring,
transmission wiring
Approx.
1/4 (7)
3/8 to 5/8
(10 – 15)
2-3/4 to 3-1/2
(70 – 90)
Strand the
wirings after
sheath is
peeled off.
(Sheath peeling
off allowance.)
After the wirings are clamped,
cut off the extra part.
Terminal block for
power supply wiring/
grounding wiring (X2M)
Terminal block for
remote controller wiring/
transmission wiring (X1M)
Printed Circuit
Board
Forced
off
Remote controller
wiring (X1M)
Transmission
wiring (X1M)
[Remote controller wiring, Transmission wiring]
• Do not connect the power supply wiring (high voltage).
Prohibited
Ground
wiring
Ground terminal
[Power supply wiring, Ground wiring]
R3/8 (10)
or more
After the
wirings are
clamped, cut off
the extra part.
(Sheath peeling off allo
w
ance
.)
Clamp (4)
(Accessory)
Sheathed
part
• Use a 90° elbow type of conduit with dimensions
Fig. 23-1 to prevent it from hitting the swing motor hous-
ing of decoration panel.
• Do not dispose the screw which assembles casing and resin together. The screw will be used to install
conduit mounting plate. Make sure to install the conduit mounting plate first before wiring.
Fig. 23-1
Fig. 23-2
01_EN_3P693452-2.indd 12
2022/08/09 16:00:14
