4
|
Components
Service manual
59
RXJ20~50A + FTXJ-A(W)(S)(B)
Split Emura 3 R32
ESIE22-04 – 2022.04
4
Install the heat exchanger thermistor in its holder.
5
Attach the wiring harnesses to the switch box as needed.
6
Connect the grounding wire to the heat exchanger using the screw.
7
Connect the power supply wiring to the power supply terminal X1M.
8
Install the power supply wiring bracket. Install and tighten the screw.
To re-install the front grille
1
Install the front grille and firmly engage the 3 upper hooks.
2
Tighten the 2 screws and put the 2 screw covers back.
3
Re-install the flap.
4
Insert the wire harness back into the connector and secure it with the wire
clamp.
5
48].
To re-install the front panel
1
Attach the front panel.
2
Align the shaft on right side with the shaft slot and insert it all the way in.
3
Push lightly the front panel to the right side, align the shaft on the left side
with slot and insert it all the way in.
4
Close the locks on both sides.
To close the front panel
1
Set the filters as they were.
2
Lift the front panel slightly and remove the support from the fixing tab.
d
c
a
a
Backside of the front panel
b
Fixing tab
c
Support
3
Close the front panel.
4
Gently press the front panel down until it clicks.
draft – 22/04/2022 08:50