Daikin EKLN140A1, Installation Manual

Page: 7 / 12

Installing the unit
EKLN140A1 Installation manual
Low sound enclosure
7
4P650154-1
–
2021.03
2. Tilt the mounting lips at the end of the slat perpendicular to the
slat.
3. Install the 2 lower slats.
Install the intermediate slats
1. The intermediate slats are positioned by tilting them into the
vertical supports. Position 4 intermediate slats on each side.
2. Bend the mounting lips 90° in respect of the slats. The lips must
be connected to the vertical supports. Hold the lip and vertical
support firmly by hand so that the holes align with one another.
3. Then, secure the lip with M5 self-tapping bolts (accessory A) and
washers (accessory B) inserted from outside.
NOTE
Tighten them hand-tight (maximum tightening torque =
5 Nm).
a Self-tapping bolt and washer
Install the upper slats
1. The upper slats are positioned by tilting them into the vertical
supports. Firstly, place the slat at the top over the vertical
supports. Then, slide the slat into the notches below in the
vertical supports.
2. Secure the 8 guide pins (accessory M) with the M5 self-tapping
bolts (accessory A). A washer is not needed in this case.
(illustration a)
3. Fit a 12×7 spacer bush (accessory O) over the upper guide pins
(4×). (illustration b)
4. Fit the 4 additional M5 self-tapping bolts (accessory A) and
washers (accessory B). (illustration c)
NOTE
Tighten them hand-tight (maximum tightening torque =
5 Nm).
a Guide pins with self-tapping bolt
b Spacer bush
c Additional self-tapping bolt
5. Fit the self-adhesive D-rubber (accessory P) to all edges. Fit the
rubber flush with the outside of the sheet edge.
INFORMATION
Dry and degrease the steel sheet to ensure that the
D-rubber adheres properly. Cut the rubber to length with
scissors.