Daikin EKLN140A1, Installation Manual

Page: 3 / 12

About the unit and options
EKLN140A1 Installation manual
Low sound enclosure
3
4P650154-1
–
2021.03
R Key
(1)
This manual refers to each part with a specific letter from A to
R.
3 About the unit and options
3.1 Possible combinations
Unit Low sound enclosure
(1)
RZAG71/100/125/140N7* O
RZA200/250D7Y1B O
RXYSA4/5/6A7* O
(1)
O = Optional
3.2 Possible options
Drain pan and heater tape
To evacuate drain water.
•
Drain pan (EKLN140-DP)
•
Heater tape (EKLN140-DPHT)
4 Installing the unit
WARNING
Installation must be carried out by an authorised installer.
Two people are required to install the low sound enclosure.
WARNING
The parts may have sharp edges. Wear cut-resistant work
gloves during installation.
4.1 Preparing the installation location
Requirements relating to the installation location of the outdoor
unit
Ensure a horizontal, level, and stable base (concrete, paving, wooden
frame). There must be a minimum clearance of 1 m on all sides of the
frame.
Tools
The unit can be installed using common tools:
•
Cut-resistant work gloves
•
Wire cutters
•
Utility knife
•
Measuring tape
•
Try square
•
Degreaser
•
Screwdriver, torx TXP25
•
(Pipe) wrench size 10
•
Key size 13
•
Drill with 8 mm masonry bit (if the foundation is made of
concrete)
4.2 Fitting the enclosure
4.2.1 Installing the base frame
Parts
Start by installing the base frame, which comprises the following parts:
a Base frame profile, front
b Base frame profile, rear
c Base frame profile, left
d Base frame profile, right
e Corner brackets for base frame
f Base frame sealing pad
Install the base frame
The base frame comprises 4 straight pieces (a~d) and 4 corners (e).
The 4 straight pieces have recesses at the ends to allow them to slot
together.
1. Tilt the corner brackets into the corners.
2. Secure the corners with M5 self-tapping bolts (accessory A) and
washers (accessory B).
NOTE
Tighten them hand-tight (maximum tightening torque =
5 Nm).
3. Affix 1 strip of sealing tape (accessory C) to the base. Affix this
in the center of the profile. Interrupt the rubber at the drainage
holes (2×).
a Sealing tape (accessory C)
4. Align the base frame perpendicular
–
a large try square would be
most appropriate for this. The corners must be fully
perpendicular (90°).