Daikin EKLN140A1, Installation Manual

Page: 4 / 12

Installing the unit
Installation manual EKLN140A1
4
Low sound enclosure
4P650154-1
–
2021.03
5. Secure the base frame to the floor with the coach bolts
(accessory E) and the sheet-metal washers (accessory F).
(Optional) If working with a stony base, use the nylon plugs
(accessory D).
6. Fit 4 round plastic spacer caps (accessory G) to the base frame.
Press them into the holes at the top, over which the panels will
be fitted later.
4.2.2 Installing the support frame
Parts
The support frame comprises the following parts:
a Support beam, front
b Support beam, rear
c Support partition, upper
d Support partition, lower
e Vibration dampers
f Rounded rubber
g Base frame sealing pad
C, H, I, L Accessories
Install the support frame
1. Position the front support beam (a) and rear support beam (b)
parallel to one another with the open sections facing one another.
2. Slide the upper support partition (c) and lower support partition
(d) between the 2 support beams.
3. Check that all holes in the support bars and partitions are aligned
with one another.
4. Connect the vibration dampers (e) to the support beams and
partitions using the M8 spring washers (accessory H).
5. Connect the support beams and partitions to one another using
the M5 self-tapping bolts (accessory A).
NOTE
Tighten them hand-tight (maximum tightening torque =
5 Nm).
6. Affix 1 strip of sealing tape (accessory C) to both support beams.
Affix this in center of the front support beam profile (a) and rear
support beam profile (b).
a Sealing tape (accessory C)
7. (Optional) As the base of the drip tray: fit the top of both
intermediate
partitions with U-shaped finishing rubber
(accessory L) on the upper part (4×). Cut the U-shaped finishing
rubber into 4 equal lengths of 3 cm and place them on the ends
of the support partitions.
8. Fit the front of the foremost support beam with rounded rubber
(f). Cut the correct lengths and ensure that the rubber is
interrupted at the notches.
9. Click the support frame into the base frame using the grooves.
a Location of groove in base frame
a Location of groove in support frame
10. Secure the foremost support beam to the floor using the coach
bolts (accessory E), sheet-metal washers (accessory F), and
plugs (accessory D) if working with a stony base.