Dahua Technology WizMind IPC-PDBW82041-B360, Operation Manual

Page: 44 / 154

Operation Manual
35
Parameter Description
ARP/Ping
Click to enable ARP/Ping to set IP address service. Get the
camera MAC address, and then you can change and configure
the device IP address with ARP/ping command.
This is enabled by default. During restart, you will have no more
than 2 minutes to configure the device IP address by a ping
packet with certain length, the server will be turned off in 2
minutes, or it will be turned off immediately after the IP address is
successfully configured. If this is not enabled, the IP address
cannot be configured with ping packet.
A demonstration of configuring IP address with ARP/Ping.
1. Keep the camera that needs to be configured and the PC
within the same local network, and then get a usable IP
address.
2. Get the MAC address of the camera from device label.
3. Open command editor on the PC and enter the following
command.
4. Restart the camera.
5. Check the PC command line, if information such as Reply
from 192.168.0.125…
is displayed, the configuration
succeeds, and you can turn it off then.
6. Enter http://(IP address) in the browser address bar to log in.
NIC
Select the Ethernet card that need to be configured, and the
default one is
Wire .
Mode
The mode that the camera gets IP:
●
Static
Configure
IP Address
,
Subnet Mask
, and
Default Gateway
manually, and then click Save , the login interface with the
configured IP address is displayed.
●
DHCP
When there is DHCP server in the network, select DHCP , and
the camera acquires IP address automatically.