6ñ14
ï
Sometimes it may seem th
while. There is no fault the
ity of other signals on the
the AF-function.
ï
When the radio switches
will go quiet for a momen
the accuracy of the PI da
ï
If you leave a reception a
frequency, the indicator "
TA-traffic announcement
When depressing the TP mod
is activated. The indicator "TP"
the tuning up or down butto
mode and searches for a
information. As soon as this
with "TP" in the display. If r
warning tone telling you to s
ñ Don't activate the TP-func
the RDS traffic informatio
tuning and preset scan w
Then after 30 seconds an
to turn off the TP function
ñ RDS traffic information co
normal FM stereo signals
Austria and Switzerland.
sounds, warning the drive
AF-function(network following)
The unit retunes to the stronger alternative transmitter in the list
of alternative frequencies(AF). The display indicates "AF" as
confirmation in the display
(18). Thus a motorist can keep listening
to the same program.
Example: If there are the following network broadcasting stations,
the reception frequency automatically changes from 98.5 MHz to
107.5 MHz to 96.0 MHz to 102.5 MHz, but a motorist can keep
listening to the same program while driving from point A to point
B.
AF-reception
The AF-function is only possible with FM. If the AF-function is
turned on the radio has tuned into an RDS transmitter and it will
automatically find the best transmitter in the particular chain of
transmitters as soon as reception starts to get worse, as long as
you are still driving within the areas of the particular areas. The
display shows the indicator "AF" in the display (18).
RDS functions of this unit
This unit has the following functions for making use of RDS data.
ï
Station name display using PS data.
ï
AF(Altermative Frequencies) reception which automatically
tunes to the stronger station which broadcasts the same
program, using PI and AF data.
ï
Automatic reception of traffic information broadcasts using TP/
TA and EON data.
ï
PTY function which searches the stations of the same PTY.
Network/station name display
When you switch on the radio and select FM bands, the unit enters
the RDS mode automatically.
When you tune into an RDS station with manual or seek tuning,
the frequency display changes to the network/station name
display by means of the PS code RDS data.
ï
The RDS function of this unit uses RDS data transmitted
along with FM broadcasts. It does not work in the MW
and LW bands.
ï
The RDS function may not work properly in the areas
where test transmissions are being conducted.
NOTE
As a result of the PS function the station display changes
over to frequency display during the manual or automatic
search for a station.
IMPORTANT
Untitled-46
10/31/2006, 12:54 PM
14
Summary of Contents for Cielo
