Daewoo Cielo, Owner'S Manual

Page: 81 / 126

7ñ4
ï Raise the vehicle by turning the crank
handle clockwise until the jack lifting
head fits firmly into the notch and the
wheel is off the ground (about 3 cm).
Do not raise the vehicle more than
necessary.
ï Remove the wheel bolts by turning
them counterclockwise and then
remove the wheel.
ï Mount the spare wheel in position and
tighten the wheel bolts hand-tight by
turning clockwise.
ï Turn the jack handle counterclockwise
and lower the vehicle to the ground.
Tighten the wheel bolts firmly in "X"
pattern (1-2-3-4).
ï Install the wheel cover.
ï Incorrect wheel bolts or improperly
tightened wheel bolts can cause
the wheel to come off. Be sure to
use the correct wheel bolts.
ï Remove any corrosion on wheel
mounting surface.
ï Never use oil or grease on bolts.
CAUTION
WITH JUMP LEADS
STARTING THE ENGINE
A car with a discharged battery may be
started by transferring electrical power
from a battery in another car.
This may be dangerous and any deviation
from the following instructions could lead
to personal injury or property damage
resulting from battery explosion, battery
acid or electrical (short circuit) burns as
well as to damage to the electrical systems
in both vehicles.
ï Never expose the battery to naked
flames or sparks.
ï Do not allow battery fluid to come into
contact with eyes, skin, fabrics or
painted surfaces. The fluid contains
sulfuric acid which can cause injuries
and damage in the event of direct
contact.
ï To lessen the risk of injury wear eye
protection when working near any
battery.
ï Make sure that the battery providing the
jump start has the same voltage as the
battery in your car (12V).
ï Do not disconnect the discharged
battery from the vehicle.
ï Switch off all unnecessary electrical