Daedong CK3520, Manual

Page: 184 / 236

7
-
1
ck3520 / ck4020 / ck4220
OIl CAPACITy [l (U.s.gal.)]
ck3520 / ck4020 5.5 (1.45)
ck4220 6.0 (1.6 )
8. run the start motor for approx.
10 seconds to distribute oil to
each part of the engine.
9. run the engine for approx. 5 min-
utes and check for proper opera-
tion through the engine oil warning
lamp. then, stop the engine. (it is
normal that the oil warning lamp is
off while the engine running)
10. check the engine oil level again
with the oil dipstick. if the level is
low, add more oil.
the engine oil filter should be
replaced when changing the en-
gine oil.
•
NOTE
The engine oil is very hot
while the engine is running
or right after the engine is
stopped. Be careful not to be
burnt.
Avoid oil contact while chang-
ing or adding engine oil and
wear eye protection to prevent
eye contact.
Prolonged and repeated con-
tact with the engine oil may
cause skin disorders and
skin cancer. If skin contact is
made, wash thoroughly with
soap or hand cleaner as soon
as possible.
keep the used oil out of reach
of children.
•
•
•
•
WARNING
To avoid injury:
Be sure to stop the engine
before changing the fluid or
replacing the filter.
Check the engine oil level
before every operation of the
tractor. If the engine oil is
insufficient, the engine can
be damaged, and this is not
covered by warranty. Be sure
to add the engine oil when its
level is below the lower limit
of the oil dipstick.
Do not dispose of used oil
and oil filter into drainage and
other places not designated
by regulations. Observe ap-
plicable regulations when dis-
posing used oil and filters.
•
•
•
CAUTION
TC220-영문-유럽,호주향-OM-07.indd 16 2018-01-15 오후 1:12:42