2)
For S8610: Install the panel of the cable management bracket by tightening the two captive screws with a flat
screwdriver and the four cross screws with a Phillips screwdriver.
3)
For S8606 B: Make the cabling opening of the cable management bracket face upward, install the cable
management bracket one by one according to the slot corresponding to line card and cabling requirements, and then
tighten the screws at the back of cable management brackets with a Phillips screwdriver.
Figure 3-23 Installing the cable management bracket for RG-S8610
Figure 3-24 Installing the Cable Management Bracket for RG-S8610/S8606 B
4)
For S8610: Fasten the cable management bracket by using the supplied cross M3 screws. (The cable management
bracket is available in two sizes, and you can select the appropriate one)
Summary of Contents for RG-S8614
