D-Link ENW-3503, User Manual

Page: 51 / 64

Appendix C
PLANET ENW-3503 User's Manual 8-3
and no fallback
N1 * When originating or answering, start
handshaking only at the communication
standard specified by S37 register and
"ATBn". During handshake, fallback to a
lower speed may occur
On Go on-line
O0 Return modem to a previously
established state (return to data mode)
O1 Begin a retrain sequence, then return to
on-line state
O3 Issue a rate re-negotiation, then return to
on-line state
P Enable pulse dialing
Qn Result code display options
Q0 * Result code enabled
Q1 Result code disabled
T Enable tone dialing
Vn Result code form
V0 Display result code in numeric form (see
also the "Result Code Options Table)
V1 * Display result code in verbose (text) form
Wn Select extended result code options
W0 CONNECT result code reports DTE
speed. Disable protocol result codes. (see
also the "Result Code Options Table")
W1 CONNECT result code reports DTE
speed. Enable protocol result codes
W2 * CONNECT result code reports DCE
speed. Enable protocol result Codes
Xn Select result codes/call progress options
X0 Display CONNECT or "1" for all speeds.
Ignore dial tone and busy tone detection
X1 Display connect message and the
modem's data rate, and an indication of
the modem's error correction and data