D-Link DXS-3600-16S, Manual

Page: 121 / 695

DXS-3600 Series 10GbE Layer 2/3 Switch CLI Reference Guide
113
Parameters
7-64 redistribute
This command is used to redistribute routing information from other routing protocols to BGP. Use the no form of this
command to disable this function.
redistribute {local | static | rip | ospf {all | internal | external | type_1 | type_2 | inter+e1 | inter+e2}} [metric
NUMBER | route-map MAP-NAME ]
no redistribute {local | static | rip | ospf} [metric | route-map]
Parameters
NETWORK-ADDRESS Specifies the network address and the sub-network mask that BGP will advertise.
For example, the format of NETWORK-ADDRESS can be 10.9.18.2/8
route-map MAP-NAME (Optional) Specifies the name of a configured route map. The route map should be
examined to filter the networks to be advertised. If not specified, all networks are
advertised.
Default None.
Command Mode Router Configuration Mode.
Address Family Configuration Mode (IPv4 Unicast and VRF).
Command Default Level Level: 8. ( EI Mode Only Command )
Usage Guideline BGP networks can be learned from connected routes, from dynamic routing, and
from static route sources.
Use this command to specify a network as local to this autonomous system and
adds it to the BGP routing table. For exterior protocols the network command
controls which networks are advertised. Interior protocols use the network command
to determine where to send updates.
The BGP will advertise a network entry if the router has the route information for this
entry if synchronize state is enabled.
You can verify your settings by entering the show ip bgp network command in the
Privileged Mode.
Example This example shows how to set up network 10.108.0.0 to be included in the BGP
updates.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#router bgp 100
DXS-3600-32S(config-router)#network 10.108.0.0/16
DXS-3600-32S(config-router)#
Example This example shows how to set up network 133.10.25.0/24 to be included in the
BGP updates and use route-map mymap1 to set the weight of routes to 2000.
DXS-3600-32S#configure terminal
DXS-3600-32S(config)#route-map mymap1 permit 1
DXS-3600-32S(config-route-map)#set weight 2000
DXS-3600-32S(config-route-map)#exit
DXS-3600-32S(config)#router bgp 100
DXS-3600-32S(config-router)#network 133.10.25.0/24 route-map mymap1
DXS-3600-32S(config-router)#
local Specifies to redistribute local routes to BGP.
static Specifies to redistribute static routes to BGP.
rip Specifies to redistribute RIP routes to BGP.