DES-7000/DES-7100 Layer 2 Switch User
’
s Guide
Using the Web-based Management Software
65
The Port Group STP parameters that can be configured are:
State
The STP State for the port or port group can be
Disabled
or
Enabled.
The
default setting STP State is
Enabled
.
Port Cost
A Port Cost can be set from 1 to 65535. The lower the number, the greater
the probability the port will be chosen to forward packets.
Priority
A Port Priority can be from 0 to 255. The lower the number, the greater the
probability the port will be chosen as the Root Port.
By Pass
If you select
No
the forward delay timer is set to zero thus bypassing the
waiting time before the listening state. Default settings is
Yes
.
The relevant CLI commands for Port Group STP are
config stp_ports
and
show stp_ports
.
Forwarding and Filtering
Use these menus to setup Multicast and Unicast forwarding and MAC Address filtering.
For relevant forwarding and filtering CLI commands please read the section titled
Layer 2 FDB
Commands
in the CLI Reference Manual.
To configure the MAC address aging time used for the forwarding table, see Advanced Settings (page
52) for web-based configuration or use the CLI command
config fdb aging_time
.
Static Unicast Forwarding
Figure 6- 18. Static Unicast Forwarding Setup
To add an entry, define the following parameters in the
Add an Entry
field:
VLAN ID
The VLAN ID number of the VLAN to which the above MAC address
belongs.
MAC Address
The MAC address to which packets will be statically forwarded.
Allowed to Go
to Slot
Allows the designation of the module on which the above MAC address
resides.
Port
Choose the port where the MAC address resides. Selecting Port 0 means
no ports are allowed.
The corresponding CLI commands for the Static Unicast Forwarding menu are
create fdb
,
delete
fdb
,
clear fdb
and
show fdb
.
Summary of Contents for DES-7000 Series
Page 111: ......
