D-Link DES-3350SR, Command Line Interface Reference Manual

Page: 177 / 379

DES-3350SR Layer 3 Fast Ethernet Switch User’s Guide
177
Command Parameters
show ipif <ipif_name 12>
Each command is listed, in detail, in the following sections.
config ipif
Purpose Used to configure an IP interface created
with the create ipif command.
Syntax
config ipif <ipif_name 12> [{ipaddress
<network_address>|vlan <vlan_name
32> |state
[enabled|disabled]}|bootp|dhcp}]
Description This command is used to configure a
previously created IP interface on the
switch.
Parameters
<ipif_name 12>
−
The name of the IP
interface.
<vlan_name 32>
−
The name of the VLAN
corresponding to the System IP interface.
<network_address>
−
IP address and
netmask of the IP interface to be created.
You can specify the address and mask
information using the traditional format
(for example, 10.1.2.3/255.0.0.0 or in
CIDR format, 10.1.2.3/16).
state [enabled|disabled]
−
Allows you to
enable or disable the IP interface.
bootp
−
Allows the selection of the BOOTP