D-Link DCS-7410, User Manual

Page: 53 / 67

53 D-Link DCS-7510 User Manual
Section 3 - Configuration
SETUP > RS-485
You may configure the RS-485 settings or communication specifications (baud rate, data bit, stop bit, and parity bit)
for your camera. RS-485 is a serial communication method for computers and devices. For your camera, RS-485 is
used to control a PAN/TILT device, such as an external camera enclosure to perform PAN and TILT movement.
Once you enable this feature, a control panel will be displayed
on the
Live Video
window that provides control over an external
camera enclosure through the RS-485 signals.
Select the protocol type from the drop-down box.
This is the identifier for each RS-485 device. The ID range is from
1 to 255 .
Enter the
Baud Rate
settings required by your RS-485
equipment. If you are not sure what settings to use, check your
RS-485 equipment’s User Manual. The default value is 2400 .
The range is from
2400
to
38400
bps.
Enter the Data Bit settings required by your RS-485 equipment.
If you are not sure what settings to use, check your RS-485
equipment’s User Manual. The default value is
8
.
Enter the Stop Bit settings required by your RS-485 equipment.
If you are not sure what settings to use, check your RS-485
equipment’s User Manual. The default value is 1 .
Enter the
Parity Bit
settings required by your RS-485 equipment.
If you are not sure what settings to use, check your RS-485
equipment’s User Manual.
For example, if the data is 011, for even parity, the parity bit is
0 to keep the number of logic-high bits even. If the parity is odd,
the parity bit is 1, resulting in 3 logic-high bits.
Support PAN-
TILT:
Protocol:
ID:
Baud Rate:
Data Bit:
Stop Bit:
Parity Bit:
Click Save Settings to save your changes, or click Don’t Save Settings to discard your changes.