26
D-Link DIR-890L User Manual
Section 3 - Installation - Access Point
Hardware Setup (continued)
Change to Access Point Mode
4. Connect wired devices to the LAN ports on your DIR-890L. Connect wireless devices to the Wi-Fi network printed on the included Wi-Fi
Configuration Card. You can also find the Wi-Fi network names and passwords printed on the label attached to the bottom your DIR-890L.
Wi-Fi Configuration Card
DIR-890L
The DIR-890L is configured to operate in Router Mode by default. To change to
Access Point mode, access the configuration utility using a web browser such as
Internet Explorer and enter
http://dlinkrouter.local./
or you may also connect
by typing the IP address of the router (by default this is
http://192.168.0.1
) in
the address bar.
If this is your first time configuring the DIR-890L, cancel out of the Setup Wizard
by clicking on the X in the upper right hand corner.
Step 1: Install your device
Step 2: Configure your Network and Wi-Fi Settings
Step 3: Set your router password
Step 4: Set up mydlink service
Welcome
Internet
Wi-Fi Client
DIR-890L
This wizard will guide you through a step-by-step process to configure your new D-Link
device.
Next
English
⌵