99.825.21 1.3/08/13
8/28
English
CDP-TW-BSY+
Performance features
-
icroprocessor controlled synchro electronics
BSY + for a precise synchronous run of up to
2 drives
-
ndividually programmable (via software SCS)
- SHEV-high speed function (fast-running
feature in OPEN-direction)
- Protection system for the main closing edge
-
ocking relief after closing
- Especially quiet motor running in ventilation mode
- Symmetrical chain outlet
- Connection via pin-and-socket connector
- Optinal with "-AS2" = protection class 2 and
"-AS3" as well as "-LS" = protection class 3
M
I
L
A synchron-group (CDP-TW -BSY+) can be count up
to 2 drives, which communicate by a bus.
Each drive has it’s own adress.
This adress is configurable with SCS.
The last drive of a synchron-group is the master,
which controls the other drive, the slave. Different
forces between the drives of a group will balanced
with intelligent force- and position control. In case of
malfunction respective cutoff of a drive or a position
difference 30 mm, all drives will shut down from the
master-drive.
≥
Functional description
Operating voltage 24 V DC!
Observe enclosed red safety slip!
Do not connect directly to the mains supply!
- Connection has to be carried out only by an
authorized electrical specialist
- Danger of violent pressure in handaccessible area
- Keep away People from the operating area of the
drive
- Keep away children from the control
- Observe pressure load diagram of the chain!
- Use only in dry rooms
- Only for inside mounting.
Use rain detector with danger of rain
(e.g. at domelights or roof windows)
- Just use unchanged original D+H parts
- Observe mounting instructions of bracket set!
Safety notes
Intended use
- Chain drive for electric opening and closing of
heavy windows and roof area
- Operating voltage 24 V DC
-
seable for smoke ventilation, D+H Euro-SHEV
according to DIN EN 12101-2 as well as
daily natural ventilation
- Only for inside mounting
U
Observe maximum pressure load of the chain!
Maximum pressure load
is not
automatically identical with maximum pressure force
of the drive!
per chain
Pressure load diagram
250
500
750
1000
1250
1500
1750
2000
1500
1000
500
0
max.
(N)
Load
Stroke
(mm)
3000
2500
per chain
total
Drive unit with 2,5 m silicone cable. Dependent on
the type of window, different bracket sets are
available separately.
Extent of supply
Trouble shooting
Visual inspection:
Wiring:
Null balance:
Call D+H Service:
Only one master and one slave drive allowed.
The adress is sticked on the drive.
Example: In a group, composed of 3 drives,
there is a master 3, a slave 2 and a slave 1drive.
Attention: only applies by factory set.
As soon as the drives were reprogrammed with
SCS the addressing might vary from
factory set addressing.
Is the group wired correctly?
Therefore look connection diagrams.
It should be null balanced. (Page 12)
Software SCS or the special magnet
MAG 502 is required.
Drives must be configured.
Software SCS is required.
