3
S
OFTWARE
–
M
OTION
S
YSTEM
C
ONFIGURATOR
NOTE:
D-BOX upgrades
the ACM firmware on a regular basis. D-BOX therefore recommends that
you update your equipment to the latest firmware version, upon reception, with the Motion
System Configurator
1
.
Each ACM comes with a default configuration based upon the Motion System architecture. Here is the list of the
factory configurations. The letters describing the actuator position refers to the next table.
MOTION SYSTEM
ARCHITECTURE
FACTORY
CONFIGURATION
ACTUATOR POSITION
(See figure below)
DESCRIPTION
1 actuator
1 YAW
Y
1 ACM-MASTER with 1 horizontal
actuator ensuring the YAW movement
of the simulator.
2 actuators
2 BACK
BL - BR
1 ACM-MASTER with 2 actuators at the
back of the pivot point on the simulator.
3 actuators
2 BACK/1 YAW
BL – BR - Y
1 ACM-MASTER with 2 actuators at the
back of the pivot point on the simulator.
1 ACM-SLAVE with 1 horizontal actuator
ensuring the YAW movement of the
simulator.
4 actuators
2 BACK/2 FRONT
BL – BR –FL - FR
1 ACM-MASTER with 2 actuators at the
front end of the simulator.
1 ACM-SLAVE with 2 actuators at the
back end of the simulator.
1
see the Motion System Configurator installation and user Manual, D-BOX document number 194-914-0010-EN3
