CYW954907AEVAL1F Evaluation Kit User Guide, Doc. No. 002-22338 Rev. **
49
Code Examples
Figure 5-3. Scan Output
Type the command
config <SSID> <password>
. This command writes the given configuration
in the Device Configuration Table (DCT). These values are stored in flash memory on the board.
Type the command
print_config
to validate if the SSID and password match and are appropri-
ately written in the DCT.
Type the command
join
. The join command joins the network specified by the SSID and password
from the DCT. Ping the Access point (usually 192.168.1.1) or 8.8.8.8 (IP address of Google, if your
AP is connected to internet) and check if the network is up and responding. The message
"Ping
Reply 11ms"
is displayed as shown in
Figure 5-4
.