© 2009 Cypress Solutions
Complete Manual: CTM-15X Firmware 1.2.0
(Revision 1.0)
10
0BActivating Your Modem
•
New NAM parameters have been downloaded
•
New MDM has been downloaded
•
IMSI has been downloaded
•
PRL has been downloaded
During updating, if any of the above data is unsuccessful, the "OTASP Timeout" message and the "OTASP
Disconnected" message will be displayed. To retry the OTASP process, click Initiate to re-start. When the
OTASP process is complete and the provisioning parameters have been committed the "OTASP
Disconnected" message will be displayed.
Click Initiate and cycle the power on the modem.
1.2.2
Manual Activation via Modem Embedded Web Browser
On the Activate page, enter the Lock code (CSL), the Phone number (MDN), and the Mobile Identification
Number (MIN).
CSL
,
MDN
and
MIN
are all required to successfully activate the data device.
The MIN entry is provided to add support for the Wireless Number Portability (WNP).
If you were provided with a MIN from your service provider then enter the 10-digit number in the MIN
field and enter the Lock code (CSL).
If you were not provided with a MIN then copy the 10-digit number for the MDN in the MIN field and
enter the Lock code (CSL).
Click Submit and cycle the power on the modem.
1.3
Command Line Activation
Note 1: Command line activation can be via a local telnet session or console session via the modem serial
interface
Note 2: Activation via the command line interface is supported only on Sierra Wireless AC595, AC597
Express Card, AC597/8 USB and AC580 data devices with the
TRU-install™ feature disabled. For all other
devices, activate the device using a laptop
There are two methods,
OTASP
is a single command entry and the simplest, if
OTASP
does not work
follow the
Manual Activation
instructions.
