CY14NVSRAMKIT-001 nvSRAM Development Kit User Guide, Doc. # 002-03522 Rev. *A
23
Kit Operation
Figure 4-6. Wait for Reset (SW1) Button Press to Continue Programming
10.Press switch SW1 as shown in
Figure 4-2
to reset the controller, then press
OK
(LED3 will blink).
The programming cycle will complete and the message shown in
Figure 4-7
is displayed. Press
OK
.
Figure 4-7. End of MCU Flash Programming
11. After the programming is complete, the other buttons, which were grayed out initially, are
enabled. However, these operations are not required to use the nvSRAM DVK.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from