CY14NVSRAMKIT-001 nvSRAM Development Kit User Guide, Doc. # 002-03522 Rev. *A
22
Kit Operation
b. Select Crystal Frequency:
4MHz
c. Select Hex File:
<Install_Directory>\CY14NVSRAMKIT-001 nvSRAM Development
Kit\1.0\Firmware\Binary\Parallel_nvSRAM.srec
The default binary file location is as follows:
Windows 7 (64-bit):
C:\Program Files (x86)\Cypress\CY14NVSRAMKIT-001 nvSRAM
Development Kit\1.0\Firmware\Binary\
Windows 7 (32-bit):
C:\Program Files\Cypress\CY14NVSRAMKIT-001 nvSRAM Devel-
opment Kit\1.0\Firmware\Binary\
d. Select the Virtual COM-port by clicking the
Set Environment
button as shown in
Figure 4-3
.
This will open a new ‘Customize setting’ window.
Figure 4-4. COM Port Setting
To identify the COM port for the Flash MCU Programmer:
Start
>
All Programs
>
Computer.
Right-click and select
Properties
>
Device Manager
>
Ports (COM & LPT)
and identify the
CMSIS-DAP Spansion Virtual Communications Port (COMx)
. For example,
Figure 4-5
shows
it is assigned to communication port 5 (COM5). Enter this value in COM to set the COM port.
Figure 4-5. Port Selection
If the CMSIS-DAP Spansion Virtual Communications Port does not appear under
Ports (COM &
LPT)
, then the driver is not installed. Refer to
2.1 Install SK-FM4-U120-9B560 Kit Software and
Driver on page 10
to install the Debug and Programming (DAP) port (CN3) driver.
9. Click the
Full Operation
button to program the device.
When the operation starts, a window pops up with the message shown in
Figure 4-6
.
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
Downloaded from
