CYP IP-7000TXWP, Operation Manual, Page: 9 / 52

4
6. OPERATION CONTROLS AND FUNCTIONS
6.1 Front Panel
IR LINE
IN IN OUT OUT
SOURCE
RS-232
HDMI IN
VGA IN
USB
LINK POWER
IP-7000TXWP
1 2 3 4 5 6
7 8 9 10 11
1 USB 2.0 (Type-B) Port:
Connect directly to a PC, or other USB host
device, to extend its USB functionality to the ports on the connected
receiver.
2 RS-232 Port:
Connect directly to your PC/laptop to send commands
to RS-232 devices connected to the linked receiver. The baud rate is
configurable, but the default baud rate is 115200.
Note: When the transmitter is in multicast mode every connected receiver
unit can send RS-232 commands to the transmitter and commands sent
from the transmitter side will be sent to all associated receivers.
3 SOURCE LED:
This LED will illuminate red when an HDMI source is live
and green when a VGA source is live. If no live sources are detected,
this LED will remain off.
4 LINK LED: If the transmitter has no network connection the LINK LED
will not illuminate. While the transmitter is attempting to establish
a connection with a receiver the LINK LED will flash. When the
transmitter has established a stable connection with a receiver the
LINK LED will illuminate solidly.