CYP IP-7000TXWP, Operation Manual, Page: 26 / 52

21
„
Maximum Bit Rate:
Set the maximum bit rate that can be used
by the output video stream. Available options are: Unlimited, 400
Mbps, 200 Mbps, 100 Mbps, 50 Mbps. Selecting “Unlimited” will use
up to the maximum available bandwidth in order to maintain a full
framerate video stream.
Note: While it is generally suggested to select “Unlimited” when
streaming 4K video sources, the amount of bandwidth required can be
very large and will limit the number of concurrent video streams.
„
Maximum Framerate:
Adjusting this slider will set the percentage
of frames from the source video to encode (2–100%). This is ideal
for reducing the bandwidth requirements of high-resolution,
but limited motion, sources such as slide presentations or
information screens.
Note: If the framerate is lowered too far with motion video sources, the
video will become noticeably choppy.
2) Audio over IP: The audio source to embed with the current video
source in the outbound AVoIP stream is selected here. Selecting “HDMI”
will embed the current HDMI video’s audio source, selecting “Line In”
will embed the Line In audio source.
Note: This setting is stored independently for each video input. By default
HDMI audio is paired with HDMI video and Line In audio is paired
with VGA video. When the Video over IP Auto Scan function has been
enabled this section will be greyed out and audio will follow the default
configuration.