CYP CR-KP1, Operation Manual

Page: 23 / 48

23
3) Remove Device:
To completely remove a device definition from the
unit, click on the “DEL” button next to the device.
Note: If a deleted device was used as the target of any commands in a
macro, those command entries will automatically be removed from the
macros as well.
6.4.5 Message Polling Tab
This tab provides controls to enable/disable or add/remove Polling
Command events. Up to 16 Polling events can be defined. Polling
Command events are used to check the current status of various functions
on Ethernet based remote devices, typically to verify power or selection
status for the purpose of changing LED colors or setting Condition Port
values.
Note: Polling events operate on independent timers once enabled.
1) Active: Once a Polling Command has been defined, it can be enabled
or disabled by clicking on the “Enable/Disable” button.
2) Edit Polling:
Clicking on the “Edit” button opens up the Edit Polling
window. Here the Polling Command’s full configuration can be set.
Click on “Save Change” to save the Polling Command’s configuration.