CYBEX FT 360, Owner'S And Service Manual

Page: 61 / 90

Cybex FT 360 Functional Trainer Owner’s Manual
Assembly
Page 6-9
! WARNING: Use extreme caution when installing the weight stack. Failure to do so
could result in injury.
NOTE: Two people will be required to perform this procedure.
4. Install Weight Stack (refer to steps 4A - 4O and Figures 5 - 7).
A. Using an external snap ring pliers, slide the lower snap ring (and wave washer) down
about two inches from the top part of the guide rod (this will provide access to the
upper ring). Repeat this step for the other guide rod. See Figure 5.
NOTE: A step ladder will be required when removing snap rings.
B. Raise one of the guide rods high enough to expose the upper snap ring. Using an
external snap ring pliers, remove upper snap ring and then lower guide rod.
C. Remove lower snap ring and wave washer.
D. Slightly lift and lean guide rods outward.
E. Using a utility knife, carefully remove the packaging material securing the half weight
to the top weight.
F. Remove the half weight and hang it on the half weight hanger (located on front).
G. Carefully remove top weight.
H. Wipe guide rods clean over entire length. Lubricate with light coating of medium
weight automotive engine oil.
I. With an assistant, carefully install each weight plate one at a time.
! WARNING: Use extreme caution as weight stack is unstable until guide rods
are secure. Failure to do so could result in injury.
Figure 5
Wave washer
and lower snap
ring
Upper snap
ring
Frame