CYBEX FT 360, Owner'S And Service Manual

Page: 77 / 90

Arm Cable Adjustment
1. Insure top plate is in full contact with lower plates, and there is no space between any
weight plate. Open the back door, and adjust threaded cable end, at center front inside of
machine, until the ball stops at the end of the arms, are just in contact with the arm
pulleys.
2. If the threaded adjustment does not have enough range, loosen the lock nut and adjust
the threaded end to the initial position, (1/8” protruding beyond the lock nut). Tighten the
cable at one or both of the other two adjustment location to absorb as much cable as
possible then adjust the threaded cable end per step 1.
3. To loosen cable reverse the procedure in steps #1 and #2.
4. Check that the selector pin will enter each weight position after adjustment, and close the
back door, and secure with four screws.
Maintenance
Page 7-7
Cybex FT 360 Functional Trainer Owner’s Manual