Setup
and Assembly
Page 5-9
Cybex Arc Trainer 620A/629A Owner’s Manual
! WARNING: Be sure that all electrical requirements are met as indicated in the specifications at
the front of the manual and at the beginning of this chapter prior to proceeding.
Use the following instructions to test the full resistance and incline range of the unit.
1.
Plug the optional power cord into a power outlet from a grounded circuit as described under
Electrical Requirements in this chapter.
NOTE:
Coil up the remainder of the power cord and place
it out of the way.
2.
Observe that the control panel will illuminate and be in the Dormant Mode when using the optional
power
adapter.
NOTE:
If you are not using the optional AC power kit, the display will not illuminate until step 4.
3.
Hold the handrails to steady yourself while you step into the pedals.
4.
Begin
pedaling.
5.
Press
the
Quick Start
key.
6.
Run the unit through its full resistance range. First press the
Resi
key until the unit
reaches its highest load (the display will show “100”). Then press the
Resistance -
key until the
unit reaches its lowest load; the display will show “0”. As you stride, you will feel the resistance
change.
NOTE:
When the unit reaches the set incline and resistance, the displays will stop flashing and remain
steadily illuminated to indicate that the desired settings have been reached.
7.
Run the unit through its full incline range. First press the Incline key until the unit reaches its
highest incline (the display will show “10”). Then press the Incline key until the unit reaches its
lowest incline (the display will show “0”).
! WARNING: Wait until all moving parts come to a complete stop before dismounting.
8.
Press
Pause/end
twice to bring the incline back to its start position, end the workout review, and
return the display to
Dormant Mode
.
9.
Wait until foot plates come to a complete stop before dismounting the unit. Hold the handrails to
steady yourself while you step off the unit.
Testing the Operation