Setup
and Assembly
Page 5-6
Cybex Arc Trainer 620A/629A Owner’s Manual
Figure 4
Lower
Display
Cable
Upper
Display
Cable
C.
Place the console/handle assembly
(#2) in the correct position on the
main frame assembly. See Figure 4.
D.
Attach the console/handle assembly
using the four washers (#13) and four
screws .375-16 x 1.50 (#11) as shown
in Figure 4.
NOTE:
Do not securely
fasten screws at this time.
NOTE:
Confirm that no cables are
pinched lowering the console.
PIVOT SHAFT
RETAINER
BHSCS/
Loctite
#2
#13
#11
E.
Place the lower left console/handle assembly support (#2) in the correct position on the main
frame assembly. See Figure 5.
F.
Apply a drop of loctite to threads of BHSCS .375-16 X 1.00 removed in step 5B and
place another drop of loctite into the shaft (where the BHCS will be threaded into).
G.
Reattach left pivot shaft retainer (removed in step 5B) using the BHSCS/loctite. See Figure 5.
H.
Repeat steps 6E and 6F for right side.
I.
Securely fasten the BHSCS in steps 5C and 5F using the 7/32” Allen wrench (#14) provided.
NOTE:
Torque the BHSCS in Figure 5 to 150 inch pounds mimimum. Ensure the mounting
plate is tight against bearing with no side play allowed.
Figure 5
#2