CONTROLLED COPY CREATED: 3/21/2014 4:59:41 PM
24
1.
Press
Sensor
on the Hubhome screen(Figure 18).
2.
Press
Off
(Figure 19).
The Hub will then display the Home Screen, and the Sensor button will be gray (disabled)(Figure 8).
3.
Remove the Sensor and Patchtogether, as one assembly.
Note:
Use care when removing the Patch. For easiest removal,slowly peel Patch from the skin
with one hand while pushing down on the skin near the edge of the Patch with the other hand.
4.
Lower the latches on both sides of the Sensor to expose the Sensor release button (Figure 21).
Figure 21: Lower Latches
5.
Useyour thumb and index finger to squeeze thetwo release buttons located on opposite sides of the
Sensor(Figure 22). This releases the Sensor from the Patch.
Figure 22: Release Sensor
6.
Store the Sensor for future use.
Caution:
Do not store or temporarily place the Sensor on any surface that could be wet (e.g.
the bathroom or kitchen counter). The pins on the back of the Sensor can trap moisture and can
result in System damage if assembled with a Patch while wet. If moisture is present,dry with a soft
cloth, paper towel, or cotton swab.
