Cybernet Elite-4i User Guide
C M O S S e t u p U t i l i t y 37
any IDE devices it finds. If it fails to find a hard disk drive, change the value to
"Manual" and change the Access Mode. Then, manually configure the drive by
entering the characteristics of the drive in the items below (Capacity, Cylinder,
Head, Precomp, etc.). Refer to your drive's documentation or look on the drive if
you need to obtain this information.
If a hard disk drive has not been installed select
NONE
and press <Enter>.
CYLINDERS Number of cylinders
HEADS
Number of heads
PRECOMP Write precomp
LANDZONE Landing zone
SECTORS
Number of sectors
Access Mode:
This item defines some special ways that can be used to access IDE hard disk drives
such as LBA (Large Block Addressing). Leave this value at "Auto" and the
system will automatically decide the fastest way to access the hard disk drive.
Press <Esc> to close the IDE device sub-menu and return to the Standard
CMOS Features page.
STANDARD CMOS FEATURES (Continued)
Drive A and Drive B (Floppy Disk Drives)
This category identifies the type of floppy disk drive A or drive B that has been
installed in the computer.
Options for these fields are:
None
No floppy drive installed
360K, 5.25" 5.25 inch PC-type standard drive; 360K byte
1.2MB, 5.25” 5.25 inch AT-type high-density drive; 1.2MB
(3.5 inch when 3 Mode is Enabled).
720K, 3.5”
3.5 inch double-sided drive; 720K byte
1.44MB, 3.5" 3.5 inch double-sided drive; 1.44MB
2.88MB, 3.5" 3.5 inch double-sided drive; 2.88MB
The "Not Installed" option could be used as an option for diskless workstations.
Video
Set this field to the type of graphics card installed in your system.
Setting Options: EGA/VGA (default), CGA 40, CGA 80, MONO
