Cybernet Elite-4i User Guide
H a r d w a r e I n s t a l l a t i o n 29
3.7.2 Connecting the Internal Power Supply
The built-in DC to DC power supply requires two connections as follows:
1. Connect the single lead connector with a clip on one side of the plastic
housing to PJ1 on the motherboard. There is only one way to plug the lead
into the ATX power connector. Press the lead connector down until the clip
snaps into place and secures the lead onto the connector.
2. Connect the DC power board 4-pin connector to PJ2 on the motherboard.
(The 6” yellow & black cable).
Figure 31 Installing the Internal Power Supply
NOTE
: The unit ships with the Power Supply installed and connected.
Warning:
Incorrect installation of the power supply could result in serious damage to the
Elite-4i and connected peripherals. Be certain the power supply is unplugged from
the AC outlet before connecting the leads from the power supply.
3.7.3 Closing the System
Carefully reverse the process of opening the system. Be sure to make the
Motherboard connections as follows: