●
Confirm before installation that the motor assembly fits
on top of the shock shaft without any issues. Make sure
that the threads without any issues.
Some suspension kits may feature different shock shafts
on the front or rear. Please take this into account before
beginning installation.
Peel the rubber cover off the motor units.
The rubber cover does not come off the harness portion
Slide the hex end of the motor onto the shock shaft. Hand
tighten the motor by turning it clock-wise until a small amount of
resistance is felt. Begin turning the motor with a flathead
screwdriver clock-wise until the unit is lightly snug.
If the motor shaft hex portion is not properly inserted into the
shock shaft, the assembly may not perform as indicated.
Do not overtighten the motor assembly or stop turning when
any irregular resistance is felt. This may result in stripped hex
bolts.
Torque down the motor assembly.
Approx 10° from stopping point indicated above.
Torque specification 3N-m (0.3kgf-m)
Never tighten the motor assembly by handling it at the
4-sided area.
Exceeding the indicated torque specifications
may apply unnecessary loads to the motor resulting in failure.
Using a flathead screwdriver, loosen the motor five
revolutions counter clock-wise to check that the it turns
smooth.
Put back the rubber cover on to the motor assembly.
Pulling the rubber covers forcefully may damage the
electrical wires. Please handle gently.
Once the control box, wiring harness, and motors have
been installed, hold down and reset the e-con2.
Reset Buttons
(hold down)
The motors will be automatically reset at this point. (Module
will check for dampening parameters)
MOTOR MAINTENANCE
Resetting the motors periodically will maintain proper dampening levels. Dampening position
may become offset if the rest procedure has not been performed for a long period.
Reapplying grease to the hex bolt periodically will prolong motor life.
Disconnect the motor connectors when performing vehicle height adjustment.
(hold down)
MOTOR
SHAFT
APPROX 10°
4-SIDED
AREA
8-SIDED
AREA
MOTOR INSTALLATION
