Page 2
Wilbur Curtis Co., Inc.
4. Level the unit left to right and front to back by rotating the feet on the bottom of
the legs.
5. Locate the drip trays, packaged inside the bowls. Position the drain hose in the
opening in the top of each tray. Then, insert the tabs on the back of the drip tray
into the holes on the front of the chassis. Push down gently to secure in place.
6. Prepare to install the dispensing levers by removing the handles from the taps.
Push in on the top of the handle with your thumb while pulling up on the bottom
with your index finger.
7. Locate the dispensing levers, packaged inside the bowls. Install them on the tap
handles. While pulling outward on both sides of the base of the dispensing lever,
insert the pins on the bottom of the handle into the base holes on the lever.
8. Lubricate the tap mounting slots using food grade lubricant.
9. Prepare the tap handle assembly for attachment. Lubricate the red rubber gasket
on the back of the tap handle assembly with food grade lubricant and insert it into
the tap hole on the bottom of the bowl. Line up the middle pins on the handle with
the mounting slots.
10. Attach the tap handle assembly. Push in with your thumb on the center of the
handle until the tap handle assembly pops into place.
SETUP INSTRUCTIONS (CONT.)
WARNING: Use the
leveling legs to level
the dispenser only. Do
not use them to adjust unit height.
Do not extend them higher than
necessary.
4
8
7
6
Drain hose
5
Lever
Base
Handle
10
Push here
9
Spring must be
between mounts
Mount
Line up as
shown
Red plug
(lubricate)