INDUSTRIES, LLC.
111 HIGGINS STREET, WORCESTER, MA 01606
CABS/BLADES/ SPREADERS/ACCESSORIES
1. VEHICLE PREP.
1.1 Remove grab handles (see fig. 1.1).
1.2 Remove, and save, the rear bolt and nut in each floorboard, as well as the
three (3) plastic pins holding the floor mat down (see fig. 1.1).
1.3 Remove, and save, the long bolts attaching the fender to the roll bar on each
side. See fig. 2.3 for bolt locations.
1.4 Tip driver’s seat forward.
2. REAR PANEL ASSEMBLY
2.1 Pre-assemble lower rear panel, rear legs, and rear window support using a
total of six (6) 3/4” long button head screws. (Note: the soft side version does
not have a rear window support). See fig. 2.1 for the all steel pre-assembly. To
attach the rear window support, use four 3/4” long button head screws, steel
washers, and nylon washers. To attach the lower rear panel, use two 3/4” but-
ton head screws, steel washers, and nylon washers.
2.2 With assistance, and from the side of the tractor, place the pre-assembled unit
behind the seat and in between the roll bar uprights. (Make sure the rubber
seal that will rest on top of the fenders is facing outwards.) Secure the top of
each rear leg to the roll bar using a roll bar bracket, 5/16” x 1” long carriage
bolts, steel washers, and locknuts. See fig. 2.2. (Note: the rounded heads of
the carriage bolts must be toward the inside of the roll bar.)
2.3 Secure the lower rear panel to the roll bar using the two bolts previously re-
moved in VEHICLE PREP. step 1.3. (See fig. 2.3.)
Fig. 1.1 Remove grab handle,
bolt, and three plastic pins
plastic pins
Fig. 2.3
Secure Lower
Rear Panel
Lower Rear Panel
bolts
Fig. 2.1 Pre-assemble Lower
Rear Panel, Rear Legs, and
Rear Window Support
not on
S.S. Cab
Fig. 2.2
Install Rear
pre-assembled
unit
Roll Bar Brackets
p. 3 of 10
JOHN DEERE 3000 SERIES HARD & SOFT SIDED CABS
