INDUSTRIES, LLC.
111 HIGGINS STREET, WORCESTER, MA 01606
CABS/BLADES/ SPREADERS/ACCESSORIES
4. SIDE FRAMES
4.1 Remove doors from side frames (for easier handling) by unlatching and slid-
ing up and off the hinge pins..
4.2 Install left and right side frames to vehicle as shown in fig. 4.2. The bottom
of the side frame is to be on top of the floorboard, but under the mat and the
bottom flange of the front cowl assembly. Push the side frame back and rein-
stall the floorboard bolt and nut that was removed in VEHICLE PREP. step
1.2. The bolt is to pass through the bottom of the side frame and the floor-
board.
4.3 Starting at the bottom bolt hole, attach frames to rear legs using 5/16 x 3/4”
long button head screws, steel washers, and nylon washers.
NOTE:
On 3000
series tractors, the mount in the fender for the grab handle will cause the top
of the frame to tip in. After installing the bottom bolt, the top of the frame
can be easily pulled into place and the top bolt installed.
4.4 Install the front cowl to the side frames using 5/16 x 3/4” long button head
screws, steel washers, and nylon washers.
5. FRONT WINDSHIELD SUPPORT
5.1 Install the front windshield support to the side frames with the bent flange
down. Install only the bottom two 5/16 x 3/4” long button head screws, steel
washers, nylon washers, and locknuts. (see fig. 5.1) (Note: the top holes will
get fasteners once the roof is installed.)
6. WINDSHIELD
6.1 With assistance, install the windshield to the windshield support (see fig.
6.1). Use four 5/16 x 1 3/4” long flat head screws and 3/4” thick plastic
spacer blocks (placed between the plastic hinge and the windshield support
as shown in fig. 6.1.1). Do not tighten.
6.2 To install windshield bottom latches into the cowl brackets, open windshield
slightly. Grasp and squeeze the spring-loaded tabs and cradle latches into
cowl brackets, aligning tab bosses with their respective mounting holes.
6.3 To close, grasp the windshield bottom edge and lift slightly while pushing
closed. Fully close latches. Align sides of windshield with side frames and
tighten hinges. HINGES ARE PLASTIC COMPONENTS. DO NOT OVER
TIGHTEN. TORQUE TO 7 FT./LBS. MAX.
Side Frames
Fig. 4.2 Install Side Frames
3/4” thick spacer
Fig. 6.1.1 Install Spacer Block
Fig. 6.1 Install Windshield
Fig. 5.1 Install Front
Windshield Support
only these two holes
p. 5 of 10
JOHN DEERE 3000 SERIES HARD & SOFT SIDED CABS
