INDUSTRIES, LLC.
111 HIGGINS STREET, WORCESTER, MA 01606
CABS/BLADES/ SPREADERS/ACCESSORIES
JOHN DEERE 3000 SERIES HARD & SOFT SIDED CABS
8. REAR WINDOW (continued)
8.2 Install rear window using same procedure as windshield. Once aligned and
tightened, open window and install gas springs to ball studs provided. Re-
lease latches from latch mounts and open window all the way in order to
snap the gas springs onto the ball studs. (see figures 8.2, 8.2.1, & 8.2.2).
Note: rear window has holes for optional wiper.
Note: rear window can be opened for ventilation, or latches can be com-
pletely released to access rear attachments.
9. FLOORBOARD (drill hole)
9.1 Align holes in bottom of front legs with those on the bottom of the side
frames. Use these lined up holes as a guide to drill an 3/8” hole through
the tractor floorboard (see fig. 9.1). Fasten each side with a 5/16 x 3/4”
long button head screw, steel washers, and locknut. Trim floor mat as neces-
sary to lay flat over side frame, then re-install the plastic pins to secure the
floor mat.
10. DOORS
10.1 Install doors onto hinges. (see fig. 10.1) Work the doors back and forth until
the hinges are completely seated. (NOTE: the hinges, inside latch, and
striker bolt can also be adjusted for proper engagement.)
10.2 On hard sided cabs, install the gas springs to the frames and doors with
the small piston end towards the door. (See fig. 10.2) Press the button on the
compression fastener to lock the gas spring to the ball stud.
10.3 On soft sided cabs, install the cable stops and hardware provided. Attach to
the same mounting tabs as shown in fig. 10.2.
WARNING:
Do not attempt
to install gas springs on soft sided doors as this will cause damage to the
doors!
10.4 Tighten all remaining bolts.
Rear Window
Fig. 8.2.2 Install Gas Springs
Gas Spring
Fig. 8.2 Install Rear Window
3/4” spacer
Fig. 8.2.1 Release latches
latches
Drill 11/32” dia. hole
Fig. 9.1 Drill out Floorboard
Fig. 10.1 Install Doors
p. 7 of 10
Fig. 10.2 Gas spring installa-
tion for hard sided doors only
