p. 4 of 10
INDUSTRIES, LLC.
111 HIGGINS STREET, WORCESTER, MA 01606
CABS/BLADES/ SPREADERS/ACCESSORIES
3. FRONT COWL
3.1
For model 42/43/4410,
pre-assemble the cowl and the cowl insert using a
total of four bolts (5/16-18 x 3/4” long), eight steel washers, four nylon
washers, and four locknuts. Note: fig. 3.1 shows the cowl insert and which
four holes to bolt up initially (bolt location “A”). Bolt the cowl insert to the
inside surface of the cowl. Note: the cowl insert and the associated hardware
is only required on model 42/43/4410 vehicles.
3.2 Next, bolt the front legs onto the inside surface of the cowl insert so that the
cowl insert becomes sandwiched between the cowl and the front legs (bolt
location “B”). Attach the front legs using a total of two bolts (5/16-18 x 3/4”
long), four steel washers, two nylon washers, and two locknuts. Install 1”
bulb rubber (approximately 52”) along the sheet metal edges as shown in
fig. 3.2. Trim any extra bulb rubber.
3.3
For all 20 series models (example: 3120, etc.)
, pre-assemble the cowl and
front legs (as shown in fig. 3.2) by fastening together at the inside hole only,
using two 5/16” x 3/4” long button head screws, steel washers, nylon wash-
ers, and locknuts. Locknuts to be on the inside surface of the cowl assembly.
Install 1” bulb rubber (approximately 52”) along the sheet metal edges as
shown in fig. 3.2. Trim any extra bulb rubber. Note: the cowl insert (shown in
fig. 3.1) and the associated hardware is only required on model 42/43/4410
vehicles.
3.4 Place cowl assembly onto tractor (as shown in fig. 3.3) with the flap of bulb
rubber extended inward towards the passenger’s compartment.
Fig. 3.1 4510 front cowl insert
A
A
A
B
B
A
Fig. 3.2 20 series front cowl assembly
(outside surface shown)
1” bulb rubber
bolt these
two places
only
cowl
front legs
Fig. 3.3 front cowl
installed (20 series shown)
bulb rubber inwards
JOHN DEERE 3000 SERIES HARD & SOFT SIDED CABS
