CAB INSTALLATION
9 of 23
Step 6: (A/C and Cab Wiring, continued)
6.6
Route the A/C harness towards the rear of the
mower, between the engine and compressor
mount, then out through the bottom of the
“
F
”
on
the side of the mower rear body.
6.7
See Fig. 6.7. Connect the bullet terminal from the
harness to the compressor, and attach the ground
lug to the bolt at the bottom
-
front of the
compressor.
Tools Required
3/8”
and
7/16”
hex wrenches or sockets
6.8
See fig. 6.8. Connect the 2
-
pin connector from the
voltage regulator attached to the rear frame of the
cab, to the 2
-
pin connector from the main A/C wire
harness. Connect the black wires with ring lugs
under the nut on the left side of the regulator.
Tools Required
3/16”
Allen key or driver
7/16”
hex wrench or socket
6.9
See fig. 6.9. Connect the 4
-
pin connector from the
regulator harness to the connector from the
voltage regulator . Connect the other end of the
harness to the dynamo mounted to the
compressor bracket.
6.10
See fig. 6.10. Use wire ties to secure the A/C
harness inside the cab, keeping wires away from
any moving parts, especially the fan and belt.
Make sure the yellow wire with bullet terminal from
the A/C harness, located near the battery, is
accessible. This will be used for cab accessories.
6.11
See fig. 6.11. Secure the wires for the Voltage
regulator together, and to the fuel hoses near the
fuel cutoff switch. Orient the fuse holders so that
the fuses will be accessible once the covers are
put on the engine.
6.12
See fig. 6.12. Secure the compressor and dynamo
wires to other wires next to the engine. Make sure
the wires can
’
t contact any hot or moving parts.
6.13
Carefully cut the excess tails from all wire ties.
Tools Required
Wire cutters or snips
Fig. 6.8 (Voltage Regulator Connections)
Fig. 6.7 (Compressor connections)
Fig. 6.9 (Dynamo connections)
Bullet
terminals
Ground lug
Dynamo
Regulator
connector
Dynamo
harness
Voltage
Regulator
Ground
lugs
Connector for
A/C harness
Connector for
dynamo
Fig. 6.10 (Secure wires under seat)
Fig. 6.11 (Secure regulator wires)
Fig. 6.12 (Secure compressor wires)
Wire Ties
Wire Ties
Wire Ties
Fuses
