CAB INSTALLATION
12 of 23
Step 9: (Cab Filler Panels)
9.1
See fig. 9.1. Place the longer strip of self
-
adhesive
arch foam
(7”
long) onto edge of the bend on the
left side of the deck height adjustment pin box.
Hardware Used
Qty
Arch P.S.A. rubber,
3/4”
wide
7”
9.2
Remove and discard the carriage bolt from the
right side front floorboard.
9.3
Per fig. 9.3, install the deck height control cover
over the pin box and deck height lever, and secure
to the cab with
1/4”
x
5/8”
lg. bolts and nuts.
Tighten snug.
Tools Required
3/8”
and
7/16”
hex wrenches or sockets
Hardware Used
Qty
1/4
-
20 x
5/8”
Flanged Hex Bolt
5
1/4
-
20 Flanged Lock Nut
5
9.4
Secure the inner flange of the deck control cover
to the front floorboard with a button head bolt,
flanged washer, and a nut underneath. Tighten
snug.
Tools Required
3/16”
Allen key or driver
1/2”
hex wrench or socket
Hardware Used
Qty
5/16
-
18 x
1”
Button Head Bolt
1
5/16”
x
1”
Steel Fender Washer
1
5/16
-
18 Flanged Lock Nut
1
9.5
Per figure 9.5, place the shorter strip of self
-
adhesive arch foam
(5.5”)
onto the back edge of
the deck control cover, to seal to the right fender /
fuel tank. Leave no visible gap at the right corner
and along the front of the tank.
Hardware Used
Qty
Arch P.S.A. rubber,
3/4”
wide
5
-
1/2”
9.6
See fig. 9.6. Remove and discard the carriage bolt
from the left side of the front floorboard, place the
left floorboard filler panel into the corner of the
front floorboard, and secure with a button head
bolt, fender washer, and nut. Adjust the panel to
remove any visible gaps as much as possible then
tighten snug.
Tools Required
3/16”
Allen key or driver
1/2”
hex wrench or socket
Hardware Used
Qty
5/16
-
18 x
1”
Button Head Bolt
1
5/16”
x
1”
Steel Fender Washer
1
5/16
-
18 Flanged Lock Nut
1
Fig. 9.6 (Left floorboard filler panel)
Fig. 9.1 (Deck control foam seal)
Fig. 9.3 (Deck Control Cover)
Fig. 9.5 (Rear deck control seal)
Remove
carriage bolt
Place arch
rubber strip
5/16”
button head
1/4
-
20 bolt
Place arch
rubber strip
