CAB INSTALLATION
13 of 23
Step 9: (Cab Filler Panels, continued)
9.7
Rotate the seat forward. Per fig. 9.7, remove the
rear bolt from the right control arm mechanism.
Place the right inner filler bracket on the outside of
the vehicle
’
s frame flange, then secure with a
5/16”
bolt through the control arm mechanism,
frame flange and into the rivet nut of the bracket.
Leave slightly loose.
Tools Required
1/2”
hex wrenches or sockets
Hardware Used
Qty
5/16
-
18 x
1”
Flanged Hex Bolt
1
9.8
See Fig. 9.8. Remove both bolts from the left side
control arm mechanism. Place 5/16 x
1
-
1/4”
lg.
bolts through the frame flange and control arm
mechanism from the outside of the flange. Place a
spacer on each bolt, then the left inner panel
bracket on the inside of the frame flange and
secure with nuts. Tighten to 11 ft
-
lbs. (15 N
-
m)
Tools Required
1/2”
hex wrenches or sockets
(open
-
end wrench to tighten)
Hardware Used
Qty
5/16
-
18 x
1
-
1/4”
Flanged Hex Bolt
2
.459”
x
5/8”
x
1/4”
Steel Spacer
2
5/16
-
18 Flanged Lock Nut
2
9.9
See Fig. 9.9. Loosen the top of the Velcro on the
vinyl boot of the right under
-
seat panel and slide
the boot over the right control lever. Slide the
parking brake lever through the slit in the rubber
seal of the under
-
seat panel. Work the panel down
into place against the fuel tank, around the wire
harness attached to the right side mower console.
Secure the panel to the bracket from step 8.7 with
two
1/4”
flanged button head bolts. Secure the
front tab of the panel to the deck control cover with
a sheet metal screw. Tighten the button head bolts
snug. Tighten the
5/16”
bolt for the bracket to 11 ft
-
lbs. (15 N
-
m). Close the Velcro of the control
lever boot around the lever.
Tools Required
5/32”
Allen key or driver
Hand drill with #2 Phillips driver
Hardware Used
Qty
1/4
-
20 x
5/8”
Flanged Button Head Bolt
2
#8 x
1/2”
Sheet Metal Screw
1
9.10
See fig. 9.10. Loosen the Velcro at the top of the
control lever boot on the left under
-
seat panel.
Slide the boot over the left control lever and into
place against the left fuel tank. Secure with two
1/4”
flanged button head bolts and tighten snug.
Close the Velcro around the control arm.
Tools Required
5/32”
Allen key or driver
Hardware Used
Qty
1/4
-
20 x
5/8”
Flanged Button Head Bolt
2
Fig. 9.8 (Left side inner panel bracket)
Fig. 9.7 (Right side inner panel bracket)
Fig. 9.9 (Right side under
-
seat panel)
Fig. 9.10 (Left side under
-
seat panel)
Remove bolt
Right side bracket
Longer bolts
Spacers
Left side bracket
button head bolts
button head bolts
Control arm boot
Control arm boot
Wire harness
#8 Sheet metal screw
Parking brake
