CAB INSTALLATION
14 of 23
Step 9: (Cab Filler Panels, continued)
9.11
See fig. 9.11. Attach the headrest mount assembly
(from step 2.4) to the rear frame with thumb
screws and fender washers. Adjust the height of
the headrest as desired, then tighten the thumb
screws finger tight.
Hardware Used
Qty
1/4
-
20 x
3/4”
Thumb Screw
4
1/4”
x
1”
Steel Fender Washer
4
Step 10: (Final steps)
10.1
Re
-
connect the negative terminal to the battery.
Tools Required
10mm hex wrench or socket
10.2
Lower the seat down. Turn on vehicle and test
operation of the A/C Unit. If the A/C Unit does not
function properly, check out the
“
Troubleshooting
”
section of this manual. See fig. 10.2 for basic A/C
operation.
10.3
Install any accessories purchased for this vehicle.
10.4
See Fig. 10.4. Raise the seat forward. Place the
lower rear panel inside the cab against the cab
panels. Secure the rear panel to the bottom of
each under
-
seat panel with a
1/4”
bolt and fender
washer. Secure the rear panel to each side frame
panel with two
1/4”
bolts and fender washers.
Secure the top of the rear panel to the rear frame
with two
1/4”
bolts (no washers here). Tighten all
bolts snug.
Tools Required
3/8”
hex wrench or socket
Hardware Used
Qty
1/4
-
20 x
5/8”
Flanged Hex Bolt
8
1/4”
x
1”
Steel Fender Washer
6
10.5
See fig. 10.5. Re
-
install doors and install gas shocks.
The end with the red tab should be attached to the side
frame of the vehicle.
The cab installation is now complete.
Fig. 10.5 (Door gas shocks, right shown)
Fig. 10.4 (Lower Rear Panel)
Thumb screw
with washer
(both sides)
Fig. 9.11 (Headrest mount)
1/4
-
20 bolts
(no washers)
1/4
-
20 bolts
with washers
Set Blower Speed
Set Temperature
Fig. 10.2 (Test A/C Unit Functionality)
Release tab
