Currier Tech Ezip, Owner'S Manual, Page: 36 / 123

36
PAS Sensor
Ring
PAS / TAG
Selector Switch
throttles
Throttles are equipped on some models of electric bicycles. Throttles
operate by rotating the throttle towards the rider much like a motorcycle.
They generally are the inner half of the right side handlebar grip and
may also contain a battery gauge. The more you twist the throttle, the
faster the motor system will propel the bicycle.
taG (twist and Go)
Before you begin riding, turn the main power switch on, then start
riding as you would ride any regular, non motor assisted bicycle. After
you have begun to ride, slowly twist the throttle (on equipped models)
towards you. The more you twist the throttle, the more motor power
will be applied to the wheels. You may feel the pedals get a “lighter”
feel than riding without the motor assisting you. Once you have twisted
the throttle all the way, the motor will accelerate you to its full speed of
about 18-20mph (28-32 km/h).
pas (pedal assist)
Electric bicycles with this system have a throttle that is only active when
the pedals are in a forward motion. A sensor ring on the bottom bracket
spindle rotates and a sensor reads this rotation.
Begin by first riding as if you are on a normal non-electric bicycle. After a
few seconds, the motor will slowly activate and ramp up to 50% power.
Then, while the pedals are in motion, you can slowly twist the throttle
towards you to activate the full motor power.
pas / taG throttle switch (if equipped)
The type of system enables the rider to select between the PAS and
TAG modes via the red thumb button (button out=PAS, button in=TAG).
Note: When using the TAG mode you will use more battery power and
thus shorten range of the bicycle.
TAG Throttle
Power and
PAS / TAG selector
buttons