46
47
How to use the Li-Ion Chargers
Before using the charger locate the voltage selector switch (Li-Ion chargers only) on the back of the charger.
Select either 115 Volts or 230 Volts depending on the country you reside in. Using the wrong voltage setting will
permanently damage the charger and/or electrical components on the hybrid electric bicycle.
1. Select the proper voltage for your country
• 115V for North American
• 230V for most of Asia and Europe
Voltage Selector
Switch
1. Connect power cord to charger then plug power
cord into wall outlet
Power Switch - turn
to “OFF” position
2. Be sure the charger’s power switch is turned “OFF” (red
light should be off)
front and rear views below
Red light
should be
“OFF”
How to use the SLA Chargers (standard)
1. Plug the charger into the outlet. The indicator light on the top of the charger
will illuminate when the charger is working properly. Refer to the sticker on the
charger for actual status light indication.
2. Insert the plug (XLR, 2v1h, DC, or 3v) into the charger port on the bike being
sure the charger plug is fully seated in the charger port. The light should be
solid red or blinking green to indicate charging however you will need to refer
to the sticker on the charger for actual status light indication, as there are
different chargers for different battery chemistries.
3. Once the battery reaches full charge, the light will return to solid green
however you will need to refer to the sticker on the charger for actual status
light indication.
4. When charging is complete, unplug the charger from the wall before removing
it from the charger port.
Charge for the full time. If the battery still has not charged, you may need to replace it.
Use only Currie Authorized SLA chargers with bicycles equipped with SLA batteries.
Using any other charger will damage the batteries and void your warranty.
!
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
1
2
3
4
XLR3 Plug
XLR4 Plug
(36 volt systems)
DC Plug
(male and female)
2v1h Plug
3v Plug
Example of SLA
Charger w/ XLR Plug