4. Load Cell Installation
PNEG-1323
Integra Feed-Link
13
Install Load Cell and Attach to
Bin Leg
1. Place load cell into load cell base, lining up
the holes. Line up the holes in the side of the
load cell with the holes in the side of the load
cell base.
2. Place pins through the holes and fasten with
a cotter pin.
3. Attach load cell top bracket to the load cell by
lining up the holes on the side and fastening
with a pin and cotter pin. Make sure the
tongue on the bracket is on the inside side of
the bin leg.
NOTE: The bin leg should rest on the load cell
bracket. DO NOT drill mounting holes too
high on the leg or the bolts will be
supporting the weight of the bin rather than
the load cell bracket.
4. Fasten load cell top bracket to the bin leg
using bolt, washer and nut through the slot in
the bracket.
5. Drill a hole into the leg through the top hole
(hole above slot) fastening to leg using bolts,
washers, and nuts included.
6. Tighten nut on anchor bolt.
Figure 4I Install Load Cell
Figure 4J Drill top hole through bin leg, using top
bracket as a guide.
Load cell
Cotter pins
Pins
Top bracket
Drill bin leg through
top hole of bracket
