CTM HS-268, Service Manual

Page: 64 / 68

62
150+-15kgf-cm 100+-10kgf-cm
SERVICE - 13 - 3
Sliding Track Repair :
If the sliding track does not come out easily (Steps 3 and 4), shake the frame
or press the folding/unfolding Button several times to fold and unfold. This will
push the sliding track out. Be careful to keep your fingers out of the way when
doing this to avoid an accident.
Please carry out the SERVICE-11 Rear Top Cover Repair SERVICE-12 Rear Lower
Cover Repair steps, and then :
1.Use a wrench (#13) to hold the nut and a hex driver (#5) to unfasten the Allen socket
screw (1pcs) holding the inner side of the sliding track.
2.Use the hex driver (#5) to unfasten the other screw (1pcs) at the front of the sliding track.
3.Push the left sliding track out from the back.
4.Pull it out from the front.
5.Take the left sliding track completely out.
※
When replacing parts or re-installing, carry out these steps in the exact reverse sequence
but also follow the “Re-installation Instructions” below.
※
To remove the right hand sliding track follow the same procedure.
Re-installation Instructions :
※
Before re-installing the sliding tracks apply a little oil to the holes
(see picture on the right) to facilitate folding and deployment.