CTM HS-268, Service Manual

Page: 43 / 68

41
50+-5kgf-cm
SERVICE - 7
Seat Repair
Seat Spring Repair
SERVICE - 7 - 1
1.Use wrench (#12) and hex key to loosen the bolts and nuts holding the seat in place
at the back.
2.Remove the bolts, nuts and washers and set them carefully aside.
3.Compress the spring inwards with the fingers and pull it out of the hole in the seat slide
bracket.
4.Pull down and hold the seat springs to release the seat latch.
5.Push the seat bracket by thumbs towards the back of scooters to release the seat from
latch.
6.When the seat is released from latch, grab the seat and push it towards the back of
scooter to remove the seat.
※
When replacing the seat, please follow the exact reverse sequence of these steps.
Please refer to SERVICE-7 Seat Repair steps first, then :
1.Remove the holding screws (6mm, 2pcs) at the front end of the seat base and.
2.take out the spring.
※
Please follow the exact
reverse sequence of these
steps for reassembly.