CTM HS-268, Service Manual

Page: 56 / 68

54
Micro Switch Repair
SERVICE - 12 - 1
Please carry out the SERVICE-12 Rear Lower Cover Repair steps first, then :
1.Find the micro switch which is located on the inside of the rear lower cover.
2.Remove the two screws (8mm, 2pcs) on the cover.
3.Take micro switch out.
※
When reinstalling, please carry out these steps in the exact reverse sequence.
Solenoid valve connector-left.
Solenoid valve connector-right.
For other connectors, please refer to the instructions in
SERVICE-11 Rear Top Cover Repair For solenoid valve
repair, please refer to SERVICE-12-3 .
Connector Instructions :
1.Connector wiring needs to be passed through the rectangular areas marked in the figure,
and the wires must be sorted according to the connector codes shown in the picture.
2.When re-installing a solenoid valve connector, make sure the locking pin is facing up
and attach the tape or sticker to prevent interference during folding. For other connectors,
please refer to the instructions in
SERVICE-11 Rear Top Cover Repair.
Re-installation Instructions :
When sorting out the wires make sure that the solenoid valve connector is
not attached or secured to the rear lower cover hook, it may interfere with
folding of the scooter, or even rip and damage the solenoid valve connector.
Pay special attention to this stage of the operation.